Hat Patch Diamond

• 4" x 2.25"
• Sublimation ready
• Re-heatable adhesive glue on back for easy attachment.
• Black threading trim
• 100% polyester

 Sublimation Instructions:

Temperature: 400 degrees for 35-40 seconds

 Print your artwork about 1/2" larger than your patch. Don't forget to reverse!

• LINT ROLL YOUR PATCH! REPEAT! LINT ROLL YOUR PATCH!
• You sublimate on the flat finish side of the patch! The shiny side is the glue.
• Place your patch with the shiny glue side down (and flat side facing up) on a piece of parchment wax paper so that when the glue warms up it will easily be removed from the shiny side of your wax paper.
• Place your artwork on top of your patch facing downwards. Use heat tape to tape your patch down onto your artwork. (Do not use adhesive spray).
• Cover everything with butcher blow-out paper
• Heat at 400 for 35-40 seconds
• Use heat gloves to remove your artwork immediately, but leave your parchment wax paper on the back of your patch on. Let it cool for 5 or 10 minutes so your glue sets up again.
• To attach your patch to your hat or garment, remove the wax paper from behind. Pre-press your garment to warm it up about 10 seconds. Now, place your patch with the glue side down on your hat and use a hat press at 300 degrees for 30-35 seconds. You can also use an iron at its hottest setting with no steam, too. But be sure to cover your patch with paper first. Additionally, you can stitch/sew your patch on as well.